Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Table 235: IDS Configuration Details (continued)
Task
Specify the type of data to be
aggregated.
Specify handling of entries in
the IDS events cache.
Set logging values for this IDS
term.
Your Action
1.
Click Aggregation next to Then.
2.
In the Comment box, enter the comment.
3.
From the Source Prefix list, select the prefix value for source
IPv4 address aggregation.
Range: 1 through 32
4.
From the Destination Prefix list, select the prefix value for
destination IPv4 address aggregation.
Range: 1 through 32
5.
From the Source Prefix Ipv6 list, select the prefix value for
source IPv6 address aggregation.
Range: 1 through 128.
6.
From the Destination Prefix Ipv6 list, select the prefix value
for destination IPv6 address aggregation.
Range: 1 through 128
1.
Click Force Entry next to Then.
2.
Select one of the following:
force-entry—To ensure that the entry has a permanent
place in the IDS cache after one event is registered.
ignore-entry—To ensure that all IDS events are ignored.
1.
Click Logging next to Then.
2.
In the Comment box, enter the comment.
3.
From the Threshold list, select the logging threshold number
of events per second.
4.
Select the Syslog check box to enable system logging.
Chapter 23: Configuring Services
417
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
Related Products for Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - CONFIGURING INTRUSION DETECTION AND PREVENTION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - API GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.2
- Juniper MEDIA FLOW CONTROLLER 2.0.4 -
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - AQL EVENT AND FLOW QUERY CLI GUIDE
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - EVENT CATEGORY CORRELATION REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - SNMP AGENT GUIDE REV 1
- Juniper STRM LOG MANAGEMENT 2008.2 - S 6-2008
Need help?
Do you have a question about the NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 and is the answer not in the manual?