Configuring Inactivity Timer (Nsm Procedure); Table 251: Hanging Termination Detection Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

M-series and MX-series Devices
442
OK—To save the changes.
Cancel—To cancel the modifications.

Table 251: Hanging Termination Detection Configuration Details

Task
Configure hanging
termination detection

Configuring Inactivity Timer (NSM Procedure)

You can configure the inactivity timer package, which allows the BGF to use message
inactivity to detect that its active gateway controller has failed using this option.
To configure Inactivity Timer in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 252 on page 443.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1. Click Add new entry next to Gateway.
2. Click H248 Properties next to gateway.
3. Expand H248 Properties.
4. Click Hanging Termination Detection next to H248
Properties.
5. In the Comment box, enter the comment.
6. From the Timerx list, select the number of seconds between
the last message exchanged for this termination and when
the BGF sends a notification to the gateway controller.
Range: 0 through 2,147,480
Copyright © 2010, Juniper Networks, Inc.