Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual page 136

M-series and MX-series Devices
104
Table 48: FPC Configuration Details (continued)
Task
Configure port-mirroring
instances.
Enable shaping on an L2TP
session.
Configure the amount of
bandwidth for tunnel
services.
Configure Port-Mirroring
Instances.
Your Action
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Port Mirror Instance next to pic and perform the
following:
Add—Adds the selected port-mirroring instances from the
Non member list to the Members list.
Remove—Removes the selected port-mirroring instances
from the Members list.
Add All—Adds all the port-mirroring instances from the
Non-members list to the Members list.
Remove All—Removes all the port-mirroring instances
from the Members list.
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Traffic Manager next to pic.
5. From the Ingress Shaping Overhead list, select the number
of CoS shaping overhead bytes to add to the packets on the
ingress side of the L2TP tunnel to determine the shaped
session packet length.
Range: 0 through 255
6. From the Egress Shaping Overhead list, select the number
of CoS shaping overhead bytes to add to the packets on the
egress interface.
Range: 0 through 255
7. From the Mode list, select the mode of shaping.
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Tunnel Service next to pic.
5. From the Bandwidth list, select the bandwidth of 1 Gbps or
10Gbps on the Packet Forwarding Engine connected to a
Gigabit Ethernet 40-port DPC.
1. Click Add new entry next to Fpc.
2. Click Port Mirror Instance next to fpc and perform the
following:
Add—Adds the selected port-mirroring instances from the
Non member list to the Members list.
Remove—Removes the selected port-mirroring instances
from the Members list.
Add All—Adds all the port-mirroring instances from the
Non-members list to the Members list.
Remove All—Removes all the port-mirroring instances
from the Members list.
Copyright © 2010, Juniper Networks, Inc.