Table 225: Session Policy Decision Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

Copyright © 2010, Juniper Networks, Inc.
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Services > Border
3.
Signaling Gateway.
Select Gateway.
4.
Add or modify settings as specified in Table 225 on page 395.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 225: Session Policy Decision Configuration Details

Task
Configure the SPDF.
Configure service classes
for the embedded SPDF.
Your Action
1. Click Add new entry next to Gateway.
2. Click Embedded Spdf next to gateway.
3. In the Comment box, enter the comment.
1. Click Service Class next to Embedded Spdf.
2. From the Service Interface list, select the name and logical
unit number of the Multiservices PIC or DPC.
3. Click Add new entry next to Service Class.
4. In the Name box, enter the identifier for the service class.
5. In the Comment box, enter the comment.
Chapter 23: Configuring Services
395