Configuring Ripng Protocol (Nsm Procedure); Configuring Ripng On The Router (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

Table 185: RIP Configuration Fields (continued)
Option
Receive
RIB Group
Send
Traceoptions

Configuring RIPng Protocol (NSM Procedure)

Configuring RIPng on the Router (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Function
Enables you to configure RIP receive
options.
The routing table group.
Enables you to configure RIP send
options.
Enables you to configure RIP protocol
level tracing options.
To have a router exchange routes with other routers, you must configure RIP next
generation (RIPng) groups and neighbors. RIPng routes received from routers not
configured as RIPng neighbors are ignored. Likewise, RIPng routes are advertised only to
routers configured as RIPng neighbors. See the following topics:
Configuring RIPng on the Router (NSM Procedure) on page 337
Configuring Graceful Restart for RIPng (NSM Procedure) on page 338
Configuring Group on page 339
Enable or Disable Receiving of Update Messages (NSM Procedure) on page 345
Configuring RIPng Send Update Messages (NSM Procedure) on page 345
Configuring RIPng Traceoptions (NSM Procedure) on page 346
To configure RIPng in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 186 on page 338.
5.
Click one:
6.
Chapter 20: Configuring Protocols
Your Action
1. Expand the tree and select
RIP
.
Receive
2. Specify the receive options.
1. Expand the tree and select
RIP
.
Group
2. Specify the comment and ribgroup
name.
1. Expand the tree and select
RIP
Send .
2. Specify the send options.
1. Expand the tree and select
RIP
.
Traceoptions
2. Expand the Traceoptions
set up the file and flag parameters.
Rib
tree and
337