Configuring Ripng Traceoptions (Nsm Procedure); Table 196: Ripng Send Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

M-series and MX-series Devices

Configuring RIPng Traceoptions (NSM Procedure)

346
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 196: RIPng Send Configuration Details

Task
Enable or disable the
sending update messages.
You can configure the RIPng traceoption using the Traceoption option.
To configure traceoptions in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 197 on page 347.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Click Send next to Ripng.
2. In the Comment box, enter the comment.
3. Select the None check box to disable sending update
messages.
Copyright © 2010, Juniper Networks, Inc.