Comparing Device Inventory In Nsm And The Cli; Viewing Device Inventory In Nsm; Figure 7: The Device Inventory Window - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

M-series and MX-series Devices
Related Topics

Comparing Device Inventory in NSM and the CLI

Viewing Device Inventory in NSM

Purpose
Action
474
For detailed information about comparing and reconciling device inventory, see the
Network and Security Manager Administration Guide.
Managing M-series and MX-series Device Software Versions on page 471
Comparing Device Inventory in NSM and the CLI on page 474
NSM and the JUNOS command-line interface (CLI) display similar information about
the device inventory, although screens rendered in NSM look different than the JUNOS
CLI. This topic provides an introduction to viewing software and hardware inventory using
NSM and compares the NSM view with the CLI output for the same device.
Viewing Device Inventory in NSM on page 474
Viewing Device Inventory from the CLI on page 476
NSM displays the hardware and software inventory for each device according to the
information it has in its database. For a device with dual Routing Engines, NSM collects
the inventory data from the master Routing Engine.
To view the device inventory, the device must be in the Managed state.
To view the device inventory, follow these steps:
In the navigation tree, select Device Manager > Devices.
1.
Right-click the device whose inventory you want to view.
2.
Select View/Reconcile Inventory.
3.
The Device Inventory window opens, similar to the example shown in Figure 7 on
page 474.

Figure 7: The Device Inventory Window

Copyright © 2010, Juniper Networks, Inc.