NetComm NL20MESH User Manual page 97

Call Forwarding All
If this feature enabled, incoming calls are forwarded to third party without any reason. It involves in two
steps: setting the forwarding number and enable the feature. Check with your VoIP Provider if your service
supports Call Forwarding.
1 Set Unconditionally Call forwarding number and Forward unconditionally in the Voice--SIP Advanced
Setting web page.
2 All incoming calls are forwarded to the third party.
Three-Way Conference
Three-way conference enables you to invite a third party to a call, and every person in the conference can
hear the other caller's voices. Check with your VoIP Provider if your service supports Conference call.
1 Assume you are in connection with a first party.
2 Press FLASH to put the first party on-hold.
3 Dial a third party.
4 After the third party answers the call, press FLASH again to invite the first party.
5 Now all three parties are in a three-way conference.
T.38 Faxing
To make a T.38 fax, first enable T.38 support on the WebUI. Then, connect a fax machine to a VoIP port of
the DSL router. The Fax machine can now be used as a normal phone, and is able to send or receive fax to
or from other fax machines on the VoIP network.
In the initial setup, faxing behaves like a normal call. After the DSL router detects the fax tone, it switches to
T.38 mode, and use it as the transmit approach.
Check with your VoIP Provider if your service supports T.38 Faxing.
Pass-Through Faxing
If T.38 support is disabled, faxing uses normal voice codec as its coding approach. Therefore, this mode is
more like normal phone calls.
Wi-Fi 6 CloudMesh Hybrid Gateway – User Guide
UG01445 v1.01 27 October 2023
97 of 123