NetComm NL20MESH User Manual page 43

Add/Edit Mobile Broadband Setup
Only one mobile cellular service can be defined at one time.
If one is not currently defined, click the Add button.
If one already exists, either click the Edit button or click the Remove button and then click the Add button.
If the service is currently connected, before you can edit it you must click the Action/Disconnect button and then click the Edit or
Note –
Remove/Add button(s).
Both the Add and the Edit buttons on the Mobile Status page open the Mobile Broadband modem setup
dialog.
F i e l d
Enable NAT
Wi-Fi 6 CloudMesh Hybrid Gateway – User Guide
UG01445 v1.01 27 October 2023
Figure 61 – Mobile Broadband setup interface
D e s c r i p t i o n
Enable NAT (Network Address Translation) is a common routing feature which
allows multiple LAN devices to appear as a single WAN IP via network address
translation. In this mode, the router modifies network traffic sent and received
to inform remote computers on the internet that packets originating from a
machine behind the router originated from the WAN IP address of the router's
internal NAT IP address. This may be disabled if a framed route configuration is
required and local devices require WAN IP addresses.
43 of 123