NetComm NL20MESH User Manual page 12

Configuring your gateway
To complete the setup, you will need the following information from your service provider:
Internet service type (ADSL/VDSL/Ethernet WAN)
⚫
Connection type (PPPoE/PPPoA/Dynamic IP/Static IP)
⚫
Other specifics depending on your connection type including 802.1P priority, VLAN Tag, WAN IP
⚫
Address, Subnet Mask and DNS Servers
VoIP settings from your service provider if you intend to use a phone with your service.
⚫
When you have the necessary information, follow these steps:
1 Push the power button on the side of the Wi-Fi 6 CloudMesh Hybrid Gateway to turn it on. Wait a few
minutes for it to complete starting up.
2 Open a web browser and type 192.168.20.1 into the address bar, then press Enter.
3 At the login screen, type admin into the Username field. In the Password field, type the unique
password printed on the label on the bottom of the gateway, then click on the Login > button
4 Follow the Basic Setup to complete the configuration.
Connecting with Wi-Fi
Your Wi-Fi Security Card includes your unique network name and password. Type the information into your
wireless device when connecting or scan the QR code that is printed on the card.
Turning Wi-Fi and lights on or off
Hold the Wi-Fi or WPS/LED buttons down for 6 seconds to toggle the Wi-Fi radio or LED indicators on or off.
Wi-Fi 6 CloudMesh Hybrid Gateway – User Guide
UG01445 v1.01 27 October 2023
Figure 2 - Connecting with Wi-Fi
12 of 123