NetComm NL20MESH User Manual page 54

F i e l d D e s c r i p t i o n
Select an A user can select a pre-configured application from the list or select the Custom
Application or Application option to create custom application settings.
Custom
Application
Trigger Port Enter the starting trigger port number (when you select Custom Application). When an
Start application is selected the port range values are automatically entered.
Trigger Port Enter the ending trigger port number (when you select Custom Application). When an
End application is selected the port range values are automatically entered.
Trigger Options include TCP, UDP or TCP/UDP.
Protocol
Open Port Enter the starting open port number (when you select Custom Application). When an
Start application is selected the port range values are automatically entered.
Open Port End Enter the ending open port number (when you select Custom Application). When an
application is selected the port range values are automatically entered.
Open Protocol Options include TCP, UDP or TCP/UDP.
DMZ Host
The CloudMesh Gateway will forward IP packets from the Wide Area Network (WAN) that do not belong to
any of the applications configured in the Virtual Servers table or being used in the Virtual Server table to the
DMZ host.
Enter the Host's IP address and click Apply to activate the DMZ host. To deactivate the DMZ Host function,
clear the IP address field and press the Save/Apply button.
Note that LAN Loopback can also be enabled.
LAN Loopback allows the LAN host to access another LAN host/server via the external IP Address of the
router. Without NAT loopback you must use the internal IP address of the device when on the LAN side.
Wi-Fi 6 CloudMesh Hybrid Gateway – User Guide
UG01445 v1.01 27 October 2023
Table 12 – NAT -- Port Trigger Configuration settings
Figure 74 – NAT – DMZ Host settings
54 of 123