NetComm NL20MESH User Manual page 94

VoIP Functionality
This section describes how to use the VoIP function of the DSL router in more detail. Some features involve 2
or 3 parties. In that case, note that all 3 parties have to be successfully registered.
Registering
Before using any VoIP functions, the DSL router must register itself to a registrar. The DSL router also must
be configured with a proxy, which relays VoIP signalling to the next hop. In fact, many implementations
integrate these two into one server, so in many cases registrar and proxy refer to the same IP.
1 Select the right interface to use for registering, depending on where proxy/registrar resides. If using
WAN link, ensure that it is already up.
2 Select the checkbox of Use SIP Registrar and fill in the IP address and port with the correct value.
3 Fill the extension information: Authentication name, Password, Cid Name and Cid Number.
4 Click Apply to take the settings into effect.
5 TEL indicator of VoIP service should be on, indicating that SIP client is successfully registered.
Placing a Call
This section describes how to place a basic VoIP call.
1 Pick up the receiver on the phone.
2 Hear the dial-tone. Dial the extension of remote party.
3 To end the dialling, wait for digit timeout, or just press # immediately.
4 After the remote party answers the call, the connection is complete.
Anonymous call
Anonymous call does not send the caller ID to the remote party. This is useful if you do not want others
know who you are. Check with your VoIP Provider if your service supports hidden caller ID.
1 Enable Anonymous calling in the Voice--SIP Advanced Setting web page.
2 Pick up the receiver on the phone.
3 Dial *68 to enable anonymous call.
4 Hang up the receiver, then place a call as normal. Your caller ID will be hidden from the receiving
phone.
Wi-Fi 6 CloudMesh Hybrid Gateway – User Guide
UG01445 v1.01 27 October 2023
94 of 123