Show Ip Access-List; Access-List Ip Mask-Precedence - Enterasys Matrix-V V2H124-24 Configuration Manual

show ip access-list

This command displays the rules for configured IP ACLs.
Syntax
show ip access-list {standard | extended} [acl_name]
• standard – Specifies a standard IP ACL.
• extended – Specifies an extended IP ACL.
- acl_name – Name of the ACL. (Maximum length: 16 characters)
Command Mode
Privileged Exec
Example
Console#show ip access-list standard
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.0.0 0.0.15.255
Console#
Related Commands
permit, deny 4-114
ip access-group (4-122)

access-list ip mask-precedence

This command changes to the IP Mask mode used to configure access control
masks. Use the no form to delete the mask table.
Syntax
[no] access-list ip mask-precedence {in | out}
• in – Ingress mask for ingress ACLs.
• out – Egress mask for egress ACLs.
Default Setting
Default system mask: Filter inbound packets according to specified IP ACLs.
Command Mode
Global Configuration
Command Usage
• A mask can only be used by all ingress ACLs or all egress ACLs.
• The precedence of the ACL rules applied to a packet is not determined by
order of the rules, but instead by the order of the masks; i.e., the first mask
that matches a rule will determine the rule that is applied to a packet.
• You must configure a mask for an ACL rule before you can bind it to a port
or set the queue or frame priorities associated with the rule.
Access Control List Commands
4
4-117