Enterasys Matrix-V V2H124-24 Configuration Manual page 72

3
Configuring the Switch
CLI – Enter the IP address of the TFTP server, specify the source file on the server,
set the startup file name on the switch, and then restart the switch.
Console#copy tftp startup-config
TFTP server ip address: 192.168.1.19
Source configuration file name: config-1
Startup configuration file name [] : startup
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#reload
To select another configuration file as the start-up configuration, use the boot
system comand and then restart the switch.
Console(config)#boot system config: startup-new
Console(config)#exit
Console#reload
This example shows how to download a PoE controller file from a TFTP server.
Console#copy tftp file
TFTP server IP address: 10.3.4.50
Choose file type:
1. config:
Source file name: 7012_007.s19
Destination file name: P-test
Write to FLASH Programming.
Write to FLASH finish.
Success.
Console#
Note: It is possible to download a PoE Controller file to a non-PoE switch, doing so will
not cause any adverse effects.
This example shows how to copy a PoE controller file from another unit in the stack.
Console#copy file controller
Unit <1-2>: 2
Choose controller type:
1. P: 2. VDSL:
Source file name: P-test
Software downloading in progress, please wait...
Unit 1 done
Console#
3-22
2. opcode 3. PD_Controller: <1-3>: 3
3. TBD <1-3>: 1
4-66
4-71
4-22
4-66
4-66