Figure 3-56. Statically Configuring A Trunk - Enterasys Matrix-V V2H124-24 Configuration Manual

3
Configuring the Switch
Web – Click Port, Trunk Membership. Enter a trunk ID of 1-6 in the Trunk field,
select any of the switch ports from the scroll-down port list, and click Add. After you
have completed adding ports to the member list, click Apply.
CLI – This example creates trunk 2 with ports 1 and 2 on the V2H124-24FX. Just
connect these ports to two static trunk ports on another switch to form a trunk.
Console(config)#interface port-channel 2
Console(config-if)#exit
Console(config)#interface ethernet 1/1
Console(config-if)#channel-group 2
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#channel-group 2
Console(config-if)#end
Console#show interfaces status port-channel 2
Information of Trunk 2
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin:
Speed-duplex:
Capabilities:
Flow control:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Operation speed-duplex: 100full
Flow control type:
Member Ports:
Console#
3-92

Figure 3-56. Statically Configuring a Trunk

100FX
00-01-F4-73-7E-21
Up
100full
100full
Enabled
Disabled
0
User
Down
Dot3X
Eth1/1, Eth1/2,
4-151
4-151
4-165
4-158