Enterasys Matrix-V V2H124-24 Configuration Manual page 204

3
Configuring the Switch
• Ingress Filtering – If ingress filtering is enabled, incoming frames for VLANs
which do not include this ingress port in their member set will be discarded at the
ingress port. (Default: Disabled)
- Ingress filtering only affects tagged frames.
- If ingress filtering is disabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be flooded to all other ports (except
for those VLANs explicitly forbidden on this port).
- If ingress filtering is enabled and a port receives frames tagged for VLANs for
which it is not a member, these frames will be discarded.
- Ingress filtering does not affect VLAN independent BPDU frames, such as GVRP
or STP. However, they do affect VLAN dependent BPDU frames, such as GMRP.
• GVRP Status – Enables/disables GVRP for the interface. GVRP must be globally
enabled for the switch before this setting can take effect. (See "Displaying Bridge
Extension Capabilities" on page 3-12.) When disabled, any GVRP packets
received on this port will be discarded and no GVRP registrations will be
propagated from other ports. (Default: Disabled)
• GARP Join Timer* – The interval between transmitting requests/queries to
participate in a VLAN group. (Range: 20-1000 centiseconds; Default: 20)
• GARP Leave Timer* – The interval a port waits before leaving a VLAN group. This
time should be set to more than twice the join time. This ensures that after a Leave
or LeaveAll message has been issued, the applicants can rejoin before the port
actually leaves the group. (Range: 60-3000 centiseconds; Default: 60)
• GARP LeaveAll Timer* – The interval between sending out a LeaveAll query
message for VLAN group participants and the port leaving the group. This interval
should be considerably larger than the Leave Time to minimize the amount of traffic
generated by nodes rejoining the group.
(Range: 500-18000 centiseconds; Default: 1000)
• Mode – Indicates VLAN membership mode for an interface. (Default: 1Q Trunk)
- 1Q Trunk – Specifies a port as an end-point for a VLAN trunk. A trunk is a direct
link between two switches, so the port transmits tagged frames that identify the
source VLAN.
with the PVID) are also transmitted as tagged frames
- Hybrid – Specifies a hybrid VLAN interface. The port may transmit tagged or
untagged frames.
• Trunk Member – Indicates if a port is a member of a trunk. To add a trunk to the
selected VLAN, use the last table on the VLAN Static Table page.
* Timer settings must follow this rule: 2 x (join timer) < leave timer < leaveAll timer
3-154
Note that frames belonging to the port's default VLAN (i.e., associated
.