Access-List Mac Mask-Precedence - Enterasys Matrix-V V2H124-24 Configuration Manual

Command Mode
Privileged Exec
Example
Console#show mac access-list
MAC access-list jerry:
permit any 00-e0-29-94-34-de ethertype 0800
Console#
Related Commands
permit, deny 4-127
mac access-group (4-132)

access-list mac mask-precedence

This command changes to MAC Mask mode used to configure access control
masks. Use the no form to delete the mask table.
Syntax
[no] access-list ip mask-precedence {in | out}
• in – Ingress mask for ingress ACLs.
• out – Egress mask for egress ACLs.
Default Setting
Default system mask: Filter inbound packets according to specified MAC ACLs.
Command Mode
Global Configuration
Command Usage
• You must configure a mask for an ACL rule before you can bind it to a port
or set the queue or frame priorities associated with the rule.
• A mask can only be used by all ingress ACLs or all egress ACLs.
• The precedence of the ACL rules applied to a packet is not determined by
order of the rules, but instead by the order of the masks; i.e., the first mask
that matches a rule will determine the rule that is applied to a packet.
Example
Console(config)#access-list mac mask-precedence in
Console(config-mac-mask-acl)#
Related Commands
mask (MAC ACL) (4-130)
mac access-group (4-132)
Access Control List Commands
4
4-129