Figure 3-95. Traffic Classes - Enterasys Matrix-V V2H124-24 Configuration Manual

3
Configuring the Switch
Command Attributes
• Priority – CoS value. (Range: 0-7, where 7 is the highest priority)
• Traffic Class* – Output queue buffer. (Range: 0-3, where 3 is the highest CoS
priority queue)
* CLI shows Queue ID.
Web* – Click Priority, Traffic Classes. Mark an interface and click Select to display
the current mapping of CoS values to output queues. Assign priorities to the traffic
classes (i.e., output queues) for the selected interface, then click Apply.
CLI* – The following example shows how to map CoS values 1 and 2 to CoS priority
queue 0, value 0 and 3 to CoS priority queue 1, values 4 and 5 to CoS priority queue
2, and values 6 and 7 to CoS priority queue 3.
Console(config)#interface ethernet 1/1
Console(config)#queue cos-map 0 1 2
Console(config)#queue cos-map 1 0 3
Console(config)#queue cos-map 2 4 5
Console(config)#queue cos-map 3 6 7
Console(config)#exit
Console#show queue cos-map ethernet 1/1
Information of Eth 1/1
CoS Value
Priority Queue: 1 0 0 1 2 2 3 3
Console#
* Mapping specific values for CoS priorities is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
3-158

Figure 3-95. Traffic Classes

: 0 1 2 3 4 5 6 7
4-214
4-216