Setting The Acl Name And Type; Configuring A Standard Ip Acl; Figure 3-46. Naming And Choosing Acls - Enterasys Matrix-V V2H124-24 Configuration Manual

Setting the ACL Name and Type

Use the ACL Configuration page to designate the name and type of an ACL.
Command Attributes
• Name – Name of the ACL. (Maximum length: 16 characters)
• Type – There are three filtering modes:
- Standard: IP ACL mode that filters packets based on the source IP address.
- Extended: IP ACL mode that filters packets based on source or destination IP
address, as well as protocol type and protocol port number. If the "TCP" protocol
is specified, then you can also filter packets based on the TCP control code.
- MAC: MAC ACL mode that filters packets based on the source or destination
MAC address and the Ethernet frame type (RFC 1060).
Web – Click Security, ACL, ACL Configuration. Enter an ACL name in the Name
field, select the list type (IP Standard, IP Extended, or MAC), and click Add to open
the configuration page for the new list.
CLI – This example creates a standard IP ACL named bill.
Console(config)#access-list ip standard bill
Console(config-std-acl)#

Configuring a Standard IP ACL

Command Attributes
• Action – An ACL can contain permit rules, deny rules, or a combination of both.
(Default: Permit rules)
• Address Type –
addresses, "Host" to specify a specific host address in the Address field, or "IP" to
specify a range of addresses with the Address and SubMask fields. (Options: Any, Host,
IP; Default: Any)
• IP Address – Specifies the source IP address.

Figure 3-46. Naming and Choosing ACLs

Specifies the source IP address. Use "Any" to include all possible
Access Control Lists
4-113
3-75
3