Table 3-5. Https Support; Figure 3-37. Https Settings - Enterasys Matrix-V V2H124-24 Configuration Manual

• When you start HTTPS, the connection is established in this way:
- The client authenticates the server using the server's digital certificate.
- The client and server negotiate a set of security protocols to use for the
connection.
- The client and server generate session keys for encrypting and decrypting data.
• The client and server establish a secure encrypted connection.
A padlock icon should appear in the status bar for Internet Explorer 5.x or above
and Netscape Navigator 4.x or above.
• The following web browsers and operating systems currently support HTTPS:
Web Browser
Internet Explorer 5.0 or later
Netscape Navigator 4.76 or later
• To specify a secure-site certificate, see "Replacing the Default Secure-site
Certificate" on page 3-58.
Command Attributes
• HTTPS Status – Allows you to enable/disable the HTTPS server feature on the
switch. (Default: Enabled)
• Change HTTPS Port Number – Specifies the UDP port number used for HTTPS/
SSL connection to the switch's web interface. (Default: Port 443)
Web – Click Security, HTTPS Settings. Enable HTTPS and specify the port number,
then click Apply.
CLI – This example enables the HTTP secure server and modifies the port number.
Console(config)#ip http secure-port 1
Console(config)#ip http secure-server
Console(config)#

Table 3-5. HTTPS Support

Operating System
Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP
Windows 98,Windows NT (with service pack 6a),
Windows 2000, Windows XP, Solaris 2.6

Figure 3-37. HTTPS Settings

User Authentication
4-32
4-31
3-57
3