Line - Enterasys Matrix-V V2H124-24 Configuration Manual

4
Command Line Interface
Command
silent-time*
databits*
parity*
speed*
stopbits*
disconnect
show line
* These commands only apply to the serial port.

line

Use this command to identify a specific line for configuration, and to process
subsequent line configuration commands.
Syntax
line {console | vty}
• console - Console terminal line.
• vty - Virtual terminal for remote console access (i.e., Telnet).
Default Setting
There is no default line.
Command Mode
Global Configuration
Command Usage
Telnet is considered a virtual terminal connection and will be shown as "Vty" in
screen displays such as show users. However, the serial communication
parameters (e.g., databits) do not affect Telnet connections.
Example
To enter console line mode, enter the following command:
Console(config)#line console
Console(config-line)#
Related Commands
show line (4-18)
show users (4-63)
4-10
Table 4-5. Line Command Syntax (Continued)
Function
Sets the amount of time the management console is inaccessible
after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command
Sets the number of data bits per character that are interpreted and
generated by hardware
Defines the generation of a parity bit
Sets the terminal baud rate
Sets the number of the stop bits transmitted per byte
Terminates a line connection
Displays a terminal line's parameters
Mode Page
LC 4-15
LC 4-15
LC 4-16
LC 4-17
LC 4-17
PE 4-18
NE, PE 4-18