Example
The following shows LACP enabled on ports 11-13. Because LACP has also been
enabled on the ports at the other end of the links, the show interfaces status
port-channel 1 command shows that Trunk1 has been established.
Console(config)#interface ethernet 1/11
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/12
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#interface ethernet 1/13
Console(config-if)#lacp
Console(config-if)#exit
Console(config)#exit
Console#show interfaces status port-channel 1
Information of Trunk 1
Basic information:
Port type:
Mac address:
Configuration:
Name:
Port admin status:
Speed-duplex: Auto
Capabilities:
Flow control status:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Operation speed-duplex: 1000full
Flow control type:
Member Ports:
Console#
lacp system-priority
This command configures a port's LACP system priority. Use the no form to restore
the default setting.
Syntax
lacp {actor | partner} system-priority priority
no lacp {actor | partner} system-priority
• actor - The local side an aggregate link.
• partner - The remote side of an aggregate link.
• priority - This priority is used to determine link aggregation group (LAG)
membership, and to identify this device to other switches during LAG
negotiations. (Range: 0-65535)
Default Setting
32768
1000T
00-00-e8-00-00-0b
Up
10half, 10full, 100half, 100full, 1000full,
Disabled
Disabled
0
lacp
Up
None
Eth1/11, Eth1/12, Eth1/13,
Link Aggregation Commands
4
4-167