Cdp Port Settings; Figure 3-68. Cdp Port Settings - Enterasys Matrix-V V2H124-24 Configuration Manual

3
Configuring the Switch
CLI – This example sets the transmit time for CDP packets to 200 seconds, the Hold
Time value to 300 seconds, and sets the CDP domain Authentication Key to
"R&D3." CDP is then enabled for the switch. The current global settings for CDP are
displayed using the show cdp command.
Console(config)#cdp timer 200
Console(config)#cdp holdtime 300
Console(config)#cdp authentication key R&D3
Console(config)#cdp auto-run
Console#show cdp
Global CDP information:
Sending CDP packets every 200 seconds
Sending a holdtime value of 300 seconds
Sending CDPvX advertisements is auto enabled
Console#

CDP Port Settings

Use the CDP Port Settings page to individually configure CDP port settings.
Command Attributes
• Port – The number of the port on the switch.
• Status – The CDP setting for the port:
- Enabled – The port always sends and receives CDP packets, except when the
switch global CDP setting is disabled.
- Disabled – The port never sends CDP packets. CDP packets received are
discarded unless the CDP global setting is disabled, in which case they are
flooded to other ports.
- Auto Enabled – The port sends and receives CDP packets. If the global CDP
setting is also "auto-enabled," the port only starts sending packets once a CDP
packet has been received on this or any other switch port.
• Trunk – Specifies if a port is a member of a trunk.
Web – Select Enterasys, CDP, Port Settings. For any selected port, set the desired
CDP action. Click Apply.
3-112

Figure 3-68. CDP Port Settings

4-74
4-73
4-72
4-74
4-76