Switchport Acceptable-Frame-Types; Switchport Ingress-Filtering - Enterasys Matrix-V V2H124-24 Configuration Manual

4
Command Line Interface
Related Commands

switchport acceptable-frame-types (4-202)

switchport acceptable-frame-types
Use this command to configure the acceptable frame types for a port. Use the no
form to restore the default.
Syntax
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
• all - The port accepts all frames, tagged or untagged.
• tagged - The port only passes tagged frames.
Default Setting
All frame types
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When set to receive all frame types, any received frames that are untagged are
assigned to the default VLAN.
Example
The following example shows how to restrict the traffic passed on port 1 to tagged
frames:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#
Related Commands
switchport mode (4-201)

switchport ingress-filtering

Use this command to enable ingress filtering for an interface. Use the no form to
restore the default.
Syntax
[no] switchport ingress-filtering
Default Setting
Disabled
4-202