Enterasys Matrix-V V2H124-24 Configuration Manual page 385

Command
clear counters
show interfaces status Displays status for the specified interface
show interfaces
counters
show interfaces
switchport
interface
Use this command to configure an interface type and enter interface configuration
mode. Use the no form to remove a trunk.
Syntax
interface interface
no interface port-channel channel-id
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-32)
• vlan vlan-id (Range: 1-4093)
Default Setting
None
Command Mode
Global Configuration
Example
To specify the port 25, enter the following command:
Console(config)#interface ethernet 1/25
Console(config-if)#
description
Use this command to add a description to an interface. Use the no form to remove
the description.
Syntax
description string
no description
string - Comment or a description to help you remember what is attached
to this interface. (Range: 1-64 characters)
Table 4-48. Interface Commands (Continued)
Function
Clears the statistics on a given interface
Displays statistics for the specified interfaces
Displays the administrative and operational status of an interface NE, PE 4-160
Interface Commands
Mode Page
PE 4-157
NE, PE 4-158
NE, PE 4-159
4-151
4