Power Over Ethernet Commands; Power Mainpower Maximum Allocation; Table 4-28. Poe Commands - Enterasys Matrix-V V2H124-24 Configuration Manual

Power over Ethernet Commands

The commands in this group control the power that can be delivered to attached
PoE devices through the V2H124-24P switch ports.
The switch's power management enables total switch power and individual port
power to be controlled within a configured power budget. Port power can be
automatically turned on and off for connected devices and a per-port power priority
can be set so that the switch never exceeds its allocated power budget. When a
device is connected to a switch port, its power requirements are detected by the
switch before power is supplied. If the power required by a device exceeds the
power budget of the port or the whole switch, power is not supplied.
Command Group
power mainpower
maximum allocation
power inline
power inline maximum
allocation
power inline priority
show power inline status Displays the current status of power management on specific
show power mainpower

power mainpower maximum allocation

Use this command to define a power budget for the V2H124-24P (power available to
all switch ports). Use the no form to restore the default setting.
Syntax
power mainpower maximum allocation [unit unit] <watts>
unit - The switch unit in the stack.
- watts - The power budget for the switch. (Range: 36 - 800 watts)
Default Setting
375 watts
Command Mode
Privileged Executive
Command Usage
• Setting a maximum power budget for the switch enables power to be
centrally managed preventing overload conditions at the power source.

Table 4-28. PoE Commands

Function
Sets the maximum power available to all switch ports
Turns power on and off for specific ports
Sets the maximum power available to specific switch ports
Sets the priority for power supplied to specific ports
ports or all ports
Displays the current status of power management for switch
Power over Ethernet Commands
Mode
GC
IC
IC
IC
PE
PE
4
Page
4-79
4-80
4-81
4-81
4-82
4-83
4-79