Line Commands; Table 4-5. Line Command Syntax - Enterasys Matrix-V V2H124-24 Configuration Manual

Command Group
Rate Limiting
Link Aggregation
Address Table
Spanning Tree
VLANs
GVRP and
Bridge Extension
Priority
Multicast Filtering
IP Interface
DNS
The access mode shown in the following tables is indicated by these abbreviations:
NE (Normal Exec)
PE (Privileged Exec)
GC (Global Configuration)
ACL (Access Control List Configuration)

Line Commands

You can access the onboard configuration program by attaching a VT100
compatible device to the switch's serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Command Function
line Identifies a specific line for configuration and starts the line
configuration mode
login Enables password checking at login
password Specifies a password on a line
timeout login Sets the interval that the system waits for a login attempt
response
exec-timeout Sets the interval that the command interpreter waits until user
input is detected
password-thresh Sets the password intrusion threshold, which limits the number of
failed logon attempts
Table 4-4. Command Group Index (Continued)
Description
Controls the maximum rate for traffic transmitted or received on a port 4-163
Statically groups multiple ports into a single logical trunk; configures
Link Aggregation Control Protocol for port trunks
Configures the address table for filtering specified addresses,
displays current entries, clears the table, or sets the aging time
Configures Spanning Tree settings for the switch
Configures VLAN settings, and defines port membership for VLAN
groups
Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for bridge extension MIB
Sets port priority for untagged frames, relative weight for each priority
queue, also sets priority for TCP/UDP traffic types, IP precedence,
and DSCP
Configures IGMP multicast filtering, query parameters, and specifies
ports attached to a multicast router
Configures the IP address and gateway for management access
Configures DNS services
IC (Interface Configuration)
LC (Line Configuration)
VC (VLAN Database Configuration)

Table 4-5. Line Command Syntax

4
Line Commands
Page
4-164
4-174
4-178
4-198
4-207
4-211
4-224
4-233
4-238
Mode Page
GC 4-10
LC 4-11
LC 4-12
LC 4-13
LC 4-13
LC 4-14
4-9