Saving Configuration Settings - Enterasys Matrix-V V2H124-24 Configuration Manual

2
Initial Configuration
In the last step, it assigns a v3 user to this group, indicating that MD5 will be used for
authentication, provides the password "greenpeace" for authentication, and the
password "einstien" for encryption.
Console(config)#snmp-server view mib-2 1.3.6.1.2.1 included
Console(config)#snmp-server view 802.1d 1.3.6.1.2.1.17 included
Console(config)#snmp-server group r&d v3 auth mib-2 802.1d
Console(config)#snmp-server user steve group r&d v3 auth md5 greenpeace
priv des56 einstien
Console(config)#
For a more detailed explanation on how to configure the switch for access from
SNMP v3 clients, refer to "Configuring SNMPv3 Management Access" on page
3-39, or refer to the specific CLI commands for SNMP starting on page 4-138.

Saving Configuration Settings

Configuration commands only modify the running configuration file and are not
saved when the switch is rebooted. To save all your configuration changes in
nonvolatile storage, you must copy the running configuration file to the start-up
configuration file using the "copy" command.
To save the current configuration settings, enter the following command:
1. From the Privileged Exec mode prompt, type "copy running-config
startup-config" and press <Enter>.
2. Enter the name of the start-up file. Press <Enter>.
Console#copy running-config startup-config
Startup configuration file name []: startup
Console#
2-10