Show Interfaces Switchport; Table 4-49. Show Interfaces Switchport Output - Description - Enterasys Matrix-V V2H124-24 Configuration Manual

4
Command Line Interface

show interfaces switchport

Use this command to display the administrative and operational status of the
specified interfaces.
Syntax
show interfaces switchport [interface]
interface
- ethernet unit/port
- unit - This is device 1.
- port - Port number.
- port-channel channel-id (Range: 1-6)
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 25.
Console#show interfaces switchport ethernet 1/22
Information of Eth 1/22
Broadcast threshold:
Lacp status:
Ingress rate limit:
Egress rate limit:
VLAN membership mode:
Ingress rule:
Acceptable frame type:
Native VLAN:
Priority for untagged traffic:
Gvrp status:
Allowed Vlan:
Forbidden Vlan:
Console#
Field
Broadcast threshold
Lacp status
VLAN membership mode Indicates membership mode as Trunk or Hybrid (See page 4-201.)
Ingress rule
4-160

Table 4-49. Show Interfaces Switchport Output - Description

Description
Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (See page 4-156.)
Shows if Link Aggregation Control Protocol has been enabled or disabled (See
page 4-166.)
Shows if ingress filtering is enabled or disabled (See page 4-202.)
Enabled, 500 packets/second
Disabled
disable,100M bits per second
disable,100M bits per second
Hybrid
Disabled
All frames
1
0
Disabled
1(u),