Notes: 1. To ensure proper screen refresh, be sure that Internet Explorer 5.x is
configured as follows: Under the menu "Tools / Internet Options / General /
Temporary Internet Files / Settings," the setting for item "Check for newer
versions of stored pages" should be "Every visit to the page."
2. When using Internet Explorer 5.0, you may have to manually refresh the
screen after making configuration changes by pressing the browser's refresh
button.
Panel Display
The web agent displays an image of the switch's ports. The Mode can be set to
display different information for the ports, including Active (i.e., up or down), Duplex
(i.e., half or full duplex), or Flow Control (i.e., with or without flow control). Clicking on
the image of a port opens the Port Configuration page as described on page 3-89.
Main Menu
Using the onboard Web agent, you can define system parameters, manage and
control the switch, and all its ports, or monitor network conditions. The following
table briefly describes the selections available from this program.
Menu
System
System Information
Switch Information
Bridge Extension
IP Configuration
File
Copy
Delete
Set Startup
Line
Console
Telnet
Figure 3-2. Ports Panel Indicators
Table 3-2. Switch Main Menu
Description
Provides basic system description, including contact information 3-8
Shows the number of ports, hardware/firmware version numbers,
and power status
Shows the bridge extension parameters
Sets the IP address for management access
Enables the transfer and copying files
Enables the deletion of files from flash memory
Sets the startup files
Sets console port connection parameters
Sets Telnet connection parameters
Navigating the Web Browser Interface
3
Page
3-8
3-10
3-12
3-14
3-17
3-18
3-18
3-18
3-23
3-23
3-25
3-3