Priority Commands; Priority Commands (Layer 2); Table 4-64. Priority Commands; Table 4-65. Priority Commands (Layer 2) - Enterasys Matrix-V V2H124-24 Configuration Manual

Example
Console#show garp timer ethernet 1/1
Eth 1/ 1 GARP timer status:
Join timer:
Leave timer:
Leaveall timer:
Console#
Related Commands
garp timer (4-209)

Priority Commands

The commands described in this section allow you to specify which data packets
have greater precedence when traffic is buffered in the switch due to congestion.
This switch supports CoS with four priority queues for each port. Data packets in a
port's high-priority queue will be transmitted before those in the lower-priority
queues. You can set the default priority for each interface, the relative weight of each
queue, and the mapping of frame priority tags to the switch's priority queues.
Command Groups
Priority (Layer 2)
Priority (Layer 3 and 4)

Priority Commands (Layer 2)

Command
queue mode
switchport priority default
queue bandwidth
queue cos map
show queue mode
show queue bandwidth
show queue cos-map
show interfaces switchport Displays the administrative and operational status of an
20 centiseconds
60 centiseconds
1000 centiseconds

Table 4-64. Priority Commands

Function
Configures default priority for untagged frames, sets queue weights,
and maps class of service tags to hardware queues
Maps TCP ports, IP precedence tags, or IP DSCP tags to class of
service values

Table 4-65. Priority Commands (Layer 2)

Function
Sets the queue mode to strict priority or Weighted
Round-Robin (WRR)
Sets a port priority for incoming untagged frames
Assigns round-robin weights to the priority queues
Assigns class-of-service values to the priority queues
Shows the current queue mode
Shows round-robin weights assigned to the priority queues
Shows the class-of-service map
interface
4
Priority Commands
Page
4-211
4-217
Mode Page
GC 4-212
IC 4-212
GC 4-213
IC 4-214
PE 4-215
PE 4-215
PE 4-216
PE 4-160
4-211