Ip Host; Clear Host - Enterasys Matrix-V V2H124-24 Configuration Manual

ip host

This command creates a static entry in the DNS table that maps a host name to an
IP address. Use the no form to remove an entry.
Syntax
[no] ip host name address1 [address2 ... address8]
• name - Name of the host. (Range: 1-64 characters)
• address1 - Corresponding IP address.
• address2 ... address8 - Additional corresponding IP addresses.
Default Setting
No static entries
Command Mode
Global Configuration
Command Usage
Servers or other network devices may support one or more connections via
multiple IP addresses. If more than one IP address is associated with a host
name using this command, a DNS client can try each address in succession,
until it establishes a connection with the target device.
Example
This example maps two address to a host name.
Console(config)#ip host rd5 192.168.1.55 10.1.0.55
Console(config)#end
Console#show hosts
Hostname
rd5
Inet address
10.1.0.55 192.168.1.55
Alias
Console#

clear host

This command deletes entries from the DNS table.
Syntax
clear host {name | *}
• name - Name of the host. (Range: 1-64 characters)
• * - Removes all entries.
Default Setting
None
Command Mode
Privileged Exec
4
DNS Commands
4-239