show gvrp configuration
Use this command to show if GVRP is enabled.
Syntax
show gvrp configuration [interface]
interface
- ethernet unit/port
- unit - This is device 1.
- port - Port number.
- port-channel channel-id (Range: 1-6)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show gvrp configuration ethernet 1/7
Eth 1/ 7:
Gvrp configuration: Disabled
Console#
garp timer
Use this command to set the values for the join, leave and leaveall timers. Use the
no form to restore the timers' default values.
Syntax
garp timer {join | leave | leaveall} timer_value
no garp timer {join | leave | leaveall}
• {join | leave | leaveall} - Which timer to set.
- timer_value - Value of timer.
Ranges:
join: 20-1000 centiseconds
leave: 60-3000 centiseconds
leavall: 500-18000 centiseconds
Default Setting
• join: 20 centiseconds
• leave: 60 centiseconds
• leaveall: 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port Channel)
GVRP and Bridge Extension Commands
4
4-209