Gaining Access To Memory Modules - Enterasys MATRIX 7H4385-49 Hardware Installation Manual

Gaining Access to Memory Modules

Figure B-2
cover)
1 DRAM SIMM
Gaining Access to Memory Modules
Before you can replace the DRAM SIMM, you must gain access to it by removing the
safety cover and the network expansion module, if one is installed. To gain access to the
DIMM, you only need to remove the safety cover.
B-4 Mode Switch Settings and Option Installations
DIMM and DRAM SIMM Locations (7H4385-49 shown without safety
2 DIMM
Electrical Hazard: To prevent exposure to an energy hazard in a 7H4385-49 connected
to an external N-POE Power System, disconnect the 48-Vdc power cable from the 48-Vdc
input connector before servicing or removing the 7H4385-49.
Riesgo Eléctrico: Para prevenir la exposicion a un riesgo electrico en una tarjeta
7H4385-49 conectada a un sistema externo de energia N-POE Power System,
desconectar el cable de poder de 48-Vdc del conector de entrada 48-Vdc antes de dar
servicio o remover la tarjeta 7H4385-49.
Elektrischer Gefahrenhinweis: Um den Schutz vor el. Schäden des Moduls
(7H4385-49) zu gewähleisten, bei Verwendung der N-POE Systeme, sollte dies bevor
man dieses entnimmt oder Servicearbeiten daran vornimmt, vom 48-Vdc Stecker getrennt
werden.
Á
À
3 Main PC board
Â