Figure 3-100. Ip Dscp Priority - Enterasys Matrix-V V2H124-24 Configuration Manual

3
Configuring the Switch
Command Attributes
• DSCP Priority Table
• Class of Service Value
Note that "0" represents low priority and "7" represent high priority.
Note: IP DSCP settings apply to all interfaces.
Web – Click Priority, IP DSCP Priority. Select a port or trunk from the Interface field.
Select an entry from the DSCP table, enter a value in the Class of Service Value
field, then click Apply.
CLI* – The following example globally enables DSCP Priority service on the switch,
maps DSCP value 1 to CoS value 0 on port 5, and then displays all the DSCP
Priority settings.
Console(config)#map ip dscp
Console(config)#interface ethernet 1/5
Console(config-if)#map ip dscp 1 cos 0
Console(config-if)#end
Console#show map ip dscp ethernet 1/5
DSCP mapping status: disabled
Port DSCP COS
--------- ---- ---
Eth 1/5
Eth 1/5
Eth 1/5
Eth 1/5
.
.
.
Eth 1/5 61
Eth 1/5 62
Eth 1/5 63
Console#
* Mapping specific values for IP Precedence is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
3-164
Shows the DSCP Priority to CoS map.
–
Maps a CoS value to the selected DSCP Priority value.
–

Figure 3-100. IP DSCP Priority

0 0
1 0
2 0
3 0
0
0
0
4-220
4-220
4-223