Power Over Ethernet; Management - Enterasys SSA-T1068-0652 Hardware Installation Manual

Power over Ethernet

Power over Ethernet
Two SSA models—SSA‐T4068‐0252 and SSA‐T1068‐0652—support both IEEE 802.3af and 802.3at
Power over Ethernet (PoE) standards, with up to 1500 watts available for PoE. Depending on your
power supply configuration, the SSA‐T4068‐0252 and SSA‐T1068‐0652 can supply PoE power to
powered devices on all 48 RJ45 ports simultaneously.
The red PoE button switches the RJ45 port LEDs to report PoE information. In PoE mode, the PWR
LED changes to indicate the power supplies installed in the SSA. For more information, see
Table 3‐2 in Chapter
For an overview of PoE, see Appendix

Management

You can manage the SSA either in‐band or out‐of‐band. In‐band remote management is possible
using the Enterasys Networks' NetSight
(CLI) via Telnet. Out‐of‐band management is provided through the RJ45 COM (Communication)
port on the front panel using a PC, a VT terminal, or a VT terminal emulator. For more
information, see "Connecting to the Network" on page 2‐16.
1-4 Introduction
3, Troubleshooting.
C, About PoE (Power over Ethernet).
®
management application or the command line interface