Table of Contents
Advertisement
[NOTE]
1.
When the X-Ring function enable, user must disable the RSTP. The X-Ring function
and RSTP function cannot exist at the same time.
2.
Remember to execute the "Save Configuration" action, otherwise the new
configuration will lose when switch power off.
Security
In this section, you can configure 802.1x and MAC address table.
802.1X/Radius Configuration
802.1x is an IEEE authentication specification that allows a client to connect to a wireless
access point or wired switch but prevents the client from gaining access to the Internet until
it provides authority, like a user name and password that are verified by a separate server.
System Configuration
After enabling the IEEE 802.1X function, you can configure the parameters of this function.
1.
IEEE 802.1x Protocol: .enable or disable 802.1x protocol.
2.
Radius Server IP: set the Radius Server IP address.
3.
Server Port: set the UDP destination port for authentication requests to the specified
Radius Server.
4.
Accounting Port: set the UDP destination port for accounting requests to the
specified Radius Server.
5.
Shared Key: set an encryption key for using during authentication sessions with the
specified radius server. This key must match the encryption key used on the Radius
Server.
6.
NAS, Identifier: set the identifier for the radius client.
86
Advertisement
Table of Contents
