Show Interfaces Transceivers - Cisco Catalyst 3560X-24P Command Reference Manual

show interfaces transceivers

show interfaces transceivers
Use the show interfaces transceivers privileged EXEC command to display the physical properties of
a small form-factor pluggable (SFP) module interface.
Syntax Description interface-id
detail
dom-supported-list
module number
properties
threshold-table
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History Release
12.2(53)SE2
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show interfaces interface-id transceiver properties command:
Switch# show interfaces gigabitethernet1/0/1 transceiver properties
Name : Gi1/0/1
Administrative Speed: auto
Operational Speed: auto
Administrative Duplex: auto
Administrative Power Inline: enable
Operational Duplex: auto
Administrative Auto-MDIX: off
Operational Auto-MDIX: off
Catalyst 3750-X and 3560-X Switch Command Reference
2-602
show interfaces [interface-id] transceiver [detail | dom-supported-list | module number |
properties | threshold-table] [ | {begin | exclude | include} expression]
(Optional) Display configuration and status for a specified physical
interface.
(Optional) Display calibration properties, including high and low numbers
and any alarm information for any Digital Optical Monitoring
(DoM)-capable transceiver if one is installed in the switch.
(Optional) List all supported DoM transceivers.
(Optional) Limit display to interfaces on module on the switch. The range
is 1 to 9. This option is not available if you entered a specific interface ID.
(Optional) Display speed, duplex, and inline power settings on an interface.
(Optional) Display alarm and warning threshold table
(Optional) Display begins with the line that matches the expression
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
OL-21522-02