Cisco Catalyst 3560X-24P Command Reference Manual page 1104

debug sw-vlan
Usage Guidelines The undebug sw-vlan command is the same as the no debug sw-vlan command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
show vlan
show vtp
Catalyst 3750-X and 3560-X Switch Command Reference
B-96
Appendix B
Description
Displays information about the types of debugging that are enabled.
Displays the parameters for all configured VLANs or one VLAN (if the
VLAN name or ID is specified) in the administrative domain.
Displays general information about VTP management domain, status, and
counters.
Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02