Debug Platform Sw-Bridge - Cisco Catalyst 3560X-24P Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform sw-bridge

Use the debug platform sw-bridge privileged EXEC command to enable debugging of the software
bridging function. Use the no form of this command to disable debugging.
Syntax Description
broadcast
control
multicast
packet
unicast
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The undebug platform sw-bridge command is the same as the no debug platform sw-bridge
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
OL-21522-02
debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
no debug platform sw-bridge {broadcast | control | multicast | packet | unicast}
Display broadcast-data debug messages.
Display protocol-packet debug messages.
Display multicast-data debug messages.
Display sent and received data debug messages.
Display unicast-data debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Command Reference
debug platform sw-bridge
B-75