Cisco Catalyst 3560X-24P Command Reference Manual page 774

show power inline
Table 2-47
Field
Cutoff Power
Oper Power
1. The configured power is the power that you manually specify or that the switch specifies by using CDP power negotiation or
This is an example of output from the show power inline police interface-id command on a standalone
switch.
Switch> show power inline priority
Interface
---------- ------ ---------- --------
Gi3/0/1
Gi3/0/2
Gi3/0/3
Gi3/0/4
Gi3/0/5
Gi3/0/6
Gi3/0/7
Gi3/0/8
Gi3/0/9
Gi3/0/10
Gi3/0/11
Gi3/0/12
Gi3/0/13
Gi3/0/14
Gi3/0/15
Gi3/0/16
Gi3/0/17
Gi3/0/18
Gi3/0/19
Gi3/0/20
Gi3/0/21
Related Commands Command
logging event
power-inline-status
power inline
show controllers
power inline
Catalyst 3750-X and 3560-X Switch Command Reference
2-742
show power inline police Field Descriptions (continued)
Description
The maximum power allocated on the port. When the real-time power
consumption is greater than this value, the switch takes the configured policing
action.
The real-time power consumption of the powered device.
the IEEE classification, which is different than the real-time power that is monitored with the power sensing feature. The
configured power values on a Catalyst 3750-X, Catalyst 3750-E, Catalyst 3650-X, or Catalyst 3560-E switch is the same as
the actual power values on a Catalyst 3750 or 3560 switch.
Admin Oper
State State
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
auto off
Description
Enables the logging of PoE events.
Configures the power management mode for the specified PoE port or for all
PoE ports.
Displays the values in the registers of the specified PoE controller.
Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
Priority
low
low
low
low
low
low
low
low
low
low
low
low
low
low
low
low
low
low
low
low
low
OL-21522-02