Debug Platform Etherchannel - Cisco Catalyst 3560X-24P Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform etherchannel

Use the debug platform etherchannel privileged EXEC command to enable debugging of
platform-dependent EtherChannel events. Use the no form of this command to disable debugging.
Syntax Description
init
link-up
rpc
warnings
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
The undebug platform etherchannel command is the same as the no debug platform etherchannel
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
OL-21522-02
debug platform etherchannel {init | link-up | rpc | warnings}
no debug platform etherchannel {init | link-up | rpc | warnings}
Display EtherChannel module initialization debug messages.
Display EtherChannel link-up and link-down related debug messages.
Display EtherChannel remote procedure call (RPC) debug messages.
Display EtherChannel warning debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Command Reference
debug platform etherchannel
B-45