Debug Platform Udld - Cisco Catalyst 3560X-24P Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform udld

Use the debug platform udld privileged EXEC command to enable debugging of the
platform-dependent UniDirectional Link Detection (UDLD) software. Use the no form of this command
to disable debugging.
Syntax Description
all
error
rpc {events | messages}
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The undebug platform udld command is the same as the no debug platform udld command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
OL-21522-02
debug platform udld [all | error | rpc {events | messages}]
no debug platform udld [all | error | rpc {events | messages}]
(Optional) Display all UDLD debug messages.
(Optional) Display error condition debug messages.
(Optional) Display UDLD remote procedure call (RPC) debug messages.
The keywords have these meanings:
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
events—Display UDLD RPC events.
•
messages—Display UDLD RPC messages.
•
Catalyst 3750-X and 3560-X Switch Command Reference
debug platform udld
B-79