Debug Platform Configuration - Cisco Catalyst 3560X-24P Command Reference Manual

debug platform configuration

debug platform configuration
Use the debug platform configuration privileged EXEC command to enable debugging of
configuration file activity across the stack. Use the no form of this command to disable debugging.
This command is supported only on Catalyst 3750-X switches.
Note
Syntax Description all
reception
transmission
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The undebug platform configuration command is the same as the no debug platform configuration
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
Catalyst 3750-X and 3560-X Switch Command Reference
B-40
debug platform configuration {all | reception | transmission}
no debug platform configuration {all | reception | transmission}
Display debug messages for all configuration file transmission and reception events
throughout the stack.
Display debug messages for configuration file reception from other stack members.
Display debug messages for configuration file transmission to other stack members.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02