Spanning-Tree Loopguard Default - Cisco Catalyst 3560X-24P Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands

spanning-tree loopguard default

Use the spanning-tree loopguard default global configuration command on the switch stack or on a
standalone switch to prevent alternate or root ports from becoming designated ports because of a failure
that leads to a unidirectional link. Use the no form of this command to return to the default setting.
Syntax Description
This command has no arguments or keywords.
Defaults
Loop guard is disabled.
Command Modes Global configuration
Command History Release
12.2(53)SE2
Usage Guidelines You can enable the loop guard feature when the switch is operating in the per-VLAN spanning-tree plus
(PVST+), rapid-PVST+, or the multiple spanning-tree (MST) mode.
Loop guard is most effective when it is configured on the entire switched network. When the switch is
operating in PVST+ or rapid-PVST+ mode, loop guard prevents alternate and root ports from becoming
designated ports, and spanning tree does not send bridge protocol data units (BPDUs) on root or alternate
ports. When the switch is operating in MST mode, BPDUs are not sent on nonboundary interfaces if the
interface is blocked by loop guard in all MST instances. On a boundary interface, loop guard blocks the
interface in all MST instances.
Loop guard operates only on interfaces that the spanning tree identifies as point-to-point.
You can override the setting of the spanning-tree loopguard default global configuration command by
using the spanning-tree guard loop interface configuration command.
Examples This example shows how to globally enable loop guard:
Switch(config)# spanning-tree loopguard default
You can verify your settings by entering the show running-config privileged EXEC command.
OL-21522-02
spanning-tree loopguard default
no spanning-tree loopguard default
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
spanning-tree loopguard default
2-813