Debug Platform Fallback-Bridging - Cisco Catalyst 3560X-24P Command Reference Manual

debug platform fallback-bridging

debug platform fallback-bridging
Use the debug platform fallback-bridging privileged EXEC command to enable debugging of the
platform-dependent fallback bridging manager. Use the no form of this command to disable debugging.
This command is not supported on switches running the LAN base feature set.
Note
Syntax Description error
retry
rpc {events | messages}
Defaults Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
If you do not specify a keyword, all fallback bridging manager debug messages appear.
The undebug platform fallback-bridging command is the same as the no debug platform
fallback-bridging command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
Catalyst 3750-X and 3560-X Switch Command Reference
B-46
debug platform fallback-bridging [error | retry | rpc {events | messages}]
no debug platform fallback-bridging [error | retry | rpc {events | messages}]
(Optional) Display fallback bridging manager error condition messages.
(Optional) Display fallback bridging manager retry messages.
(Optional) Display fallback bridging debugging information. The
keywords have these meanings:
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B
events—Display remote procedure call (RPC) events.
•
messages—Display RPC messages.
•
Catalyst 3750-X and 3560-X Switch Debug Commands
OL-21522-02