Reload - Cisco Catalyst 3560X-24P Command Reference Manual

reload

reload
Use the reload privileged EXEC command to reload the stack member and to put a configuration change
into effect.
Note This command is supported only on Catalyst 3750-X switches.
Syntax Description LINE
at
cancel
in
slot stack-member-number
standby-cpu
Defaults
Immediately reloads the stack member and puts a configuration change into effect.
Command Modes Privilege EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
If there is more than one switch in the switch stack, and you enter the reload slot stack-member-number
command, you are not prompted to save the configuration.
Examples This example shows how to reload the switch stack:
Switch(config)# reload
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
This example shows how to reload a specific stack member:
Switch(config)# reload slot 6
Proceed with reload? [confirm] y
This example shows how to reload a single-switch switch stack (there is only one member switch):
Switch(config)# reload slot 3
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
Catalyst 3750-X and 3560-X Switch Command Reference
2-478
reload [LINE | at | cancel | in | slot stack-member-number | standby-cpu]
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Specify the reason for the reload.
Specify the time in hh:mm for the reload to occur.
Cancel the pending reload.
Specify a time interval in mmm or hhh:mm for reloads to occur.
Save the changes on the specified stack member and restart it.
Reload the standby route processor (RP).
OL-21522-02