Cisco Catalyst 3560X-24P Command Reference Manual page 961

Chapter 2 Catalyst 3750-X and 3560-X Cisco IOS Commands
You can use the no vlan access-map name [number] command with a sequence number to delete a single
entry.
In global configuration mode, use the vlan filter interface configuration command to apply the map to
one or more VLANs.
For more information about VLAN map entries, see the software configuration guide for this release.
Examples
This example shows how to create a VLAN map named vac1 and apply matching conditions and actions
to it. If no other entries already exist in the map, this will be entry 10.
Switch(config)# vlan access-map vac1
Switch(config-access-map)# match ip address acl1
Switch(config-access-map)# action forward
This example shows how to delete VLAN map vac1:
Switch(config)# no vlan access-map vac1
Related Commands Command
action
match (access-map configuration)
show vlan access-map
vlan filter
OL-21522-02
Description
Sets the action for the VLAN access map entry.
Sets the VLAN map to match packets against one or more access
lists.
Displays information about a particular VLAN access map or all
VLAN access maps.
Applies the VLAN access map to one or more VLANs.
Catalyst 3750-X and 3560-X Switch Command Reference
vlan access-map
2-929