Ip Igmp Filter - Cisco Catalyst 3560X-24P Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

ip igmp filter

Use the ip igmp filter interface configuration command on the switch stack or on a standalone switch
to control whether or not all hosts on a Layer 2 interface can join one or more IP multicast groups by
applying an Internet Group Management Protocol (IGMP) profile to the interface. Use the no form of
this command to remove the specified profile from the interface.
Syntax Description profile number
Defaults
No IGMP filters are applied.
Command Modes Interface configuration
Command History Release
12.2(53)SE2
Usage Guidelines You can apply IGMP filters only to Layer 2 physical interfaces; you cannot apply IGMP filters to routed
ports, switch virtual interfaces (SVIs), or ports that belong to an EtherChannel group.
An IGMP profile can be applied to one or more switch port interfaces, but one port can have only one
profile applied to it.
Examples
This example shows how to apply IGMP profile 22 to a port:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# ip igmp filter 22
You can verify your setting by using the show running-config privileged EXEC command and by
specifying an interface.
Related Commands Command
ip igmp profile
show ip dhcp snooping
statistics
OL-21522-02
ip igmp filter profile number
no ip igmp filter
The IGMP profile number to be applied. The range is 1 to 4294967295.
Modification
This command was introduced.
Description
Configures the specified IGMP profile number.
Displays the characteristics of the specified IGMP profile.
Catalyst 3750-X and 3560-X Switch Command Reference
ip igmp filter
2-255