Debug Ip Igmp Snooping - Cisco Catalyst 3560X-24P Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug ip igmp snooping

Use the debug igmp snooping privileged EXEC command to enable debugging of Internet Group
Management Protocol (IGMP) snooping activity. Use the no form of this command to disable debugging.
Syntax Description
group
management
querier
router
timer
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The undebug ip igmp snooping command is the same as the no debug ip igmp snooping command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
debug platform ip
igmp snooping
show debugging
OL-21522-02
debug ip igmp snooping [group | management | querier | router | timer]
no debug ip igmp snooping [group | management | querier | router | timer]
(Optional) Display IGMP snooping group activity debug messages.
(Optional) Display IGMP snooping management activity debug messages.
(Optional) Display IGMP snooping querier debug messages.
(Optional) Display IGMP snooping router activity debug messages.
(Optional) Display IGMP snooping timer event debug messages.
Modification
This command was introduced.
Description
Displays information about platform-dependent IGMP snooping activity.
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Command Reference
debug ip igmp snooping
B-21